- Installation size: NEMA 34/flange dimension 86mm
- Protection class: Motor housing IP65 (shaft seal IP52)
- Holding torque: 5.90Nm
- Nominal current: 6.40A
- Motor connections: Metric M17 connectors (pivoting ± 90°)
- Brake voltage: 24V
- Integrated brake for vertical loads
drylin® E stepper motor with connector, encoder and brake, NEMA 34
drylin® E stepper motor with connector, encoder and brake, NEMA 34
NEMA34: The power pack in the large installation sizeApplications with higher loads are implemented using the largest series. Heavy-duty format adjustments or parallel dual axis setups are among its primary duties.
Stepper motors from igus® are a good supplement to drylin® linear axes. They are characterised by their cost-effectiveness, their precision and easy control. They work reliably under the most varied environmental conditions (depending on the selected class of protection IP). The igus® stepper motors can be connected to the most common motor controls using standardised electrical connection.
The encoder sends signals from the motor to the motor control. The encoder verifies that the required linear motion has occurred precisely as required. Encoder = increased machine accuracy.
The brake can hold the payload in position when the motor is not under power. This is used as a safety feature during power failures – strongly recommended for vertically mounted systems.
drylin® D1 motor control system for stepper, DC and EC/BLDC motors
- A wide range of automation tasks by simple parameterisation, no programming necessary
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
You can find all relevant documents in the downloads below.
TEST BEFORE INVEST - Try out the motor control system here with the online simulation before you buy it
Preis:Upon request
igus-icon-lieferzeit
Delivery time on request
drylin® D2 motor control system for stepper, DC and EC/BLDC motors
- A wide range of automation tasks by simple parameterisation, no programming necessary
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
You can find all relevant documents in the downloads below.
Further information on dryve D1 info page
Preis:Upon request
igus-icon-lieferzeit
Delivery time on request
igus-icon-3arrow
drylin® motor expert
Purchase advice for electric motors
igus-icon-3arrow
drylin® E dryve Experience
With the dryve Experience, we would like to support you in the design, commissioning and also in the elimination of problems. You will find detailed tutorial videos of all functionalities for the respective motor control.
igus-icon-3arrow
